code flash empty

[wanji]

hi ...i already want to try recover flash using SPS08090f.bin...but after to do system-manifest the tftp server no response..ping to the server got reply is alive...and then my code flash empty how to add again ya using tftp server

my setup :

setenv ip addr 192.168.1.5

setenv serverip 192.168.1.4

setenv netmask 255.255.255.0

setenv gatewayip 192.168.1.254

setenv image_name SPS08090f.bin

update primary

[Chandini]

Hi Team 

Thank you for reaching us. 

From the details I suppose you are trying to flash the image to the switch. I have mentioned link below which has steps you can use to recover the switch. 

Software Recovery Link:

• https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re...

I hope this helps

Thanks 

[wanji]

hi..i already do this...ALL IS OK...but refer to image ...code flash empty..how to insert ya?

[Chandini]

Hi Wanji

Ack and Noted. If the switch is booting up correctly then it should display those details. Would you be able to share output of below commands 

• Show version 
• Show run

Also could you please let me know if you are from Lennar Homes ? 

Thanks 

[wanji]

hi bro..i'm not from lennar homes....below are pictures of sh run and sh version

sh version :

sh run :