RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

Could not get IP Address when trying to connect to wifi.

I have Zone Director 1200 and 11 Zoneflex R700. I also have 5 SSID configured.SSID A and SSID B are on the same VLAN/Subnet. It works fine on 10 R700. My problem is I cannot connect to SSID A on 1 of my R700 and it says that could not get ip address,...

Client Cannot Connect To Guest Wifi

Hi I have a Client that cannot to the Guest WIFI. They were able to connect before using guest Passes.

802.11v BSS Transition Management check

Hi I am trying to see if 802.11v is enabled CLI command rkscli: get bss-trans-mgmt wlan1 when I enter this I getBSS Transition Management:enabledOKrkscli: get station wlan32 infoMAC Addr AID Rate RSSI VLAN Idle ERP State Flags RecvSigStrengt...

R720 802.3bt support

I have read conflicting information (datasheets) on whether or not R720 supports 802.3bt. Can someone verify if R720 indeed supports 802.3bt?

Creating a MESH with multiple AP's

I have recently bought in to Ruckus APs. Some config points below before the questionInitially, I was using a R310 200.7.10.202.94I have now purchased 2x R610'sThe internal IP range is 192.168.1.X The ISP router is 192.168.0.XIn between the WAN and L...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

1