RUCKUS Indoor and Outdoor Access Points (APs)

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Ruckus Wireless

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

R770 Cant access WebUI

I am trying to set up a R770 access point. I was unable to access the WebUI. I was able to SSH in to the unit. When I first did it made me change the password.Next, I used the "set HTTPS enable" command and was able to finally see the WebUI page. ...

Basic AP Install

Can I configure a T350SE out of the box as a standalone AP (basic setup, no ZD, no controller, just plain old Wi-Fi) without any issues down the road? I currently have the SSIDs programmed the way I want them, but the CTL light is still blinking (bec...

unable to connect R650 to ZD1200

we have ZD1200 Device and we are recently purchased R650 Access Points when we connect to ZD it wont connect ZD1200 Firmware : 10.1.2.0 build 306R650 Firmware : 114.0.0.0.6565please give me solution

Resolved! unable to connect R650 to ZD1200

we have ZD1200 Device and we are recently purchased R650 Access Points when we connect to ZD it wont connect please give me solution

How to check if BeamFlex+ is enable on R770?

I recently replaced an old access point with a R770. However, i hasn't noticed any improvement in performance compared to the old setup-especially in weaker coverage areas like corners of the building.I'd like to know how to verify whether BeamFlex+ ...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

1

1