CommScope RUCKUS Community Forums

pluto09 · 06-18-2023

Hello Communityhow can i change the firmware version in the Default Zone in the vSZ? I want to downgrade the fw version, with it supports all of my AP's, the older ones too.Thank you

pluto09 · 06-15-2023

Hello Community,the migration process of a t300 AP hangs. I waited 1 hour, but nothing occurs. Then i restartet the VSZ by CLI an now, if i try the migration again theres a error: "There is another migration activity in progress, please try again lat...

pluto09 · 06-26-2023

Hi,now i made it! The hint with the certificates of the AP's was right. Now i have imported any of our AP's correctly.Thank you for your support!

pluto09 · 06-23-2023

pluto09 · 06-23-2023

Hi,some of the AP's now were imported and some not. I tried the solution with the certificates, but the command no ap-cert-check doesnt work.Any idea?

pluto09 · 06-20-2023

Hi @Amith,this sounds good. Why must i flash the AP firmware first? Can i not run the "set scg ip" without flashing?Thanks you!Franz

pluto09 · 06-19-2023

Now i created the rule with ip-adress, but if i migrate from the old ZD it creates a new Zone "ZD_ZoneX" with firmware 6.xWhat am I doing wrong? I'm confused!

CommScope RUCKUS Community Forums

User Statistics

User Activity

Default Zone - change Firmware Version

Migrate t300 AP from ZD1200 to VSZ 6.1.1.0.959 hangs

Re: Default Zone - change Firmware Version

Re: Migrate t300 AP from ZD1200 to VSZ 6.1.1.0.959 hangs

Re: Migrate t300 AP from ZD1200 to VSZ 6.1.1.0.959 hangs

Re: Default Zone - change Firmware Version

Re: Default Zone - change Firmware Version