CommScope RUCKUS Community Forums

gsfakian · 07-19-2023

Hi to all... on the same area i have two differnet networks one with vSZ and some ruckus APs and another network with Unifi Controller and APs... i can see that ruckus detect many of the unifis as Rogue and probably blocks them.. (i cannot fully unde...

gsfakian · 05-05-2023

Hi to all, i am having a vSZ on version 6 with about 60 APs (models R500,R510,R700,R750,T301S). They all running on huawei switches with almost default setup except guests vlan. I am getting a lot of mac flapping errors on the switches especially in ...

gsfakian · 03-20-2023

Hi to all... having some older APs migrated to my new vSZ i noticed that any access point running on 5.2.2.0.2064 fw (in the corresponding zone) do not have any WLAN assigned on them and they do not broadcast at all... My licenses are ok, all access ...

gsfakian · 03-15-2023

Hi to all, trying to migrate from old ZD to vSZ noticed that if for any reason the controller restarts or the AP fails to complete the migration then this stage stucks for ever. Every time i try to restart the process i get the error that another mig...

gsfakian · 03-15-2023

Hi to all.I am reading in release notes that its possible to adopt older models like R500 & T300/301 by putting them in a different zone which uses older AP version.. But how can i create such a zone? Whenever i try to create a new one the firmware v...

gsfakian · 03-20-2023

pfff... after a full reboot of the controller this fixed!... I didn't think about it as more than the half of newer models were working fine... ADMINS may delete this thread.. thank you

gsfakian · 03-16-2023

Thank you very much!.. This solved the problem!..I am still wondering if also the ZD migration procedure could succeed in a similar way... Every old AP that starts migration fails... and as i can see i believe this happens because vSZ tries to flash ...

gsfakian · 03-15-2023

Thank you, meanwhile i did another "set-factory" and start over. If it hangs again i will open a case.

gsfakian · 03-15-2023

Thank you very much. I found documentation about changing a zone firmare but nowhere was mentioned 'how' to make this firmware appear in the menus.. So i uploaded the 5.2.2 patch and my AP (R500) is running also 5.2.2 having a valid certificate. But ...

gsfakian · 03-15-2023

I had already opened a case.. and finally problem solved. Ruckus support rocks!.. The problem was that the certificate file was completely missing from the AP and it was not possible to upload it from GUI. It was showing that the procedure was done b...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Rogue APs detection / exceptions

A lot of mac flapping / Roaming settings

vSZ 6.1.1.0.959 - Older models (R500,T301s) do not broadcast WLAN.. (not assigned) - solved

vSZ 6.1.1 migration stuck

vSZ 6.1.1 and older access points (r500 & t301)

Re: vSZ 6.1.1.0.959 - Older models (R500,T301s) do not broadcast WLAN.. (not assigned) - solved

Re: vSZ 6.1.1 and older access points (r500 & t301)

Re: vSZ 6.1.1 migration stuck

Re: vSZ 6.1.1 and older access points (r500 & t301)

Re: R710 cannot migrate from ZD3050 to sVZ 6.1.1