When monitoring an AP in the ZoneDirector (Firmware 9.5.2.0), the Radios are sometimes switched around. I have details about a 7372 that shows "Radio 802.11g/n" on the left, and "Radio 802.11a/n" on the right, and another 7372 that has the 5GHz on th...
In the ZD when I select an AP to monitor, under Performance there is a graph showing the RF Pollution in history.
What is this value? What unit? How is it calculated? How does it help me?
For example: I have an AP with RF Pollution of 26 whatsicle...
I have two APs, and I'm not sure if the labels are right. One is supposed to be a zf7762, the other a zf7762s.
My zonedirector reports both as zf7762. Does that mean they are not 7762s devices, or would a 7762s also be listed in the zonedirector as...
Is there a setting in the ZoneDirector to tell an AP to move all clients to neighbor APs?
I would like to shut one AP down, but without interrupting the clients where possible.
If not, I could turn the radio of that AP to low, hoping the clients w...
I got a second hand 7363, but it refuses to reset to the normal factory settings. If I reset it (holding reset button 6 seconds, restarting with reset button pressed, holding for 180 seconds), it will always go back to sending SSID "CableWifi" and "B...
That's interesting. I still have these firmware files sitting in a folder, without fiddling with a ZD. I'm pretty sure I downloaded them from the Ruckus support site a while ago:
2925_5.0.3.0.199.Bl72925_6.0.3.0.21.Bl72925_7.0.1.0.3.Bl72925_7.1.0.0.3...
That is odd. Wanna try against a ZD I have here? See if that will give the same results? I have a spare zd1012 that is reachable from internet. It will have a different FW than yours, so that might trigger the upgrade.
I haven't tried it myself, but this should work:
Go to access control, Device Access Policy. Create a policy (don't forget to press OK):
Now go to wlan, advanced options. Select the device policy in the Access Control section of the advanced optio...
