Hi Marcelo,Follow the steps below to recover from a lost password:1. Start a CLI session over the serial interface to the device2. Reboot the device3. At the initial boot prompt at system startup, enter b to enter the boot monitor mode4. Enter no pas...
Hi Brian,Thank you so much for the clarification. Please make sure the the unleashed AP is deployed in different network (vlan) from the controller deployed network. If still facing issue and need remote assistance to look in to the issue means pleas...
Hi Brian,If you want to deploy an AP as an unleash AP. Disconnect the AP from the controller and factory reset. Once factory reset it upload the unleash version firmware in the AP so that it will work as unleash AP and it will not join the controller...
Hi Netoyed,You can disable to auto approval by entering in the CLI of vSZ.Kindly click the following link for the steps to disable the auto approval : https://support.ruckuswireless.com/articles/000004585
Hi Margior,Try factory once again then login with default password sp-admin. Still if its not working means console in to the switch and try the following method from the article to recover the password : https://support.ruckuswireless.com/articles/0...