Just new to this kind of setup so please please bear with me 🙂
I can't somehow enter privileged mode when remoting via ssh. After logging in, instead of being started on limited mode ( ex. ruckus> ). It starts of with rkscli: typing in enable only shows command is not recognized: enable.
Is there something I need to tick off for the prompt to let me enter privileged mode?
Is your AP already configured and running on Unleashed? If yes, try below
- SSH into the any AP in the network (Since you posted this query under Unleashed product, I am assuming you have a working Unleashed setup with one or more APs). - Now run the command "get election" - Above command will give you a list of all APs connected to Unleashed network with all the other information about the APs (MAC add, IP, firmware ver, current role, etc). Try to find-out master AP (master AP acts as controller in Unleashed and will be labeled as 'master' in get election output) - Now check the IP address of master AP from the same output (get election output). - SSH into the master and this time when you will login, you will see 'ruckus>' prompt - To go to enable mode, run 'enable' and to move to AP mode for master AP, run 'ap-mode'
Regards, Syamantak Omer
Syamantak Omer | Community moderator | Staff TSE | CWNA | CCNA | RASZA | RICXI | Follow me at https://linkedin.com/in/syamantak-omer-5949b6124