Solved: sz144-D connecting it to a switch - Page 2 - RUCKUS Community Forums

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

Ruckus Wireless

|

Following quick set up talks about the SZ 144-D config but does not explain how the NIC's need to connect?

https://ruckus-support.s3.amazonaws.com/private/documents/3409/SZ144-D-QuickSetupGuide-800-72550-001...

Just mentions to connect Port 1 or 2 to the switch/router but that's about it. What about the 10Gig ports? What are the 4 x 1 Gig ports for and 4 x 10 Gig ports for?

And when I connect multiple ports, can they be port channeled/LAG? I'm guessing it needs to be Active if they can be LAGed?

2 ACCEPTED SOLUTIONS

Hi Ali,

LAG is supported on SZ144-D.

It is supported max 1Gx4 and 10Gx4 ports.

Image_ images_messages_5f91c45e135b77e247a4c74b_d9cdde679aea3694192110146a90ff59_RackMultipart20201013556301bsp-376979c8-6582-48df-a74e-ba7bf3d82090-1603433194.png1602594349

Regards,
Syamantak Omer

Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

View solution in original post

There are two port groups for the SZ144-D.

The first PG1 is all ports combined management and ap tunnel traffic. Therefore all ports can be used for management and AP tunnel data.

PG2 is as follows.

Eth 1 and eth 2 are for management and ap control

Eth 3 and eth 4 are for 1Gbps AP tunnel data and the 10G sfps would be part of PG2 for 10Gbps AP tunnel data.

I believe LAG of these ports will be available shortly in a future release.

View solution in original post

3 REPLIES 3