09-29-2023 12:23 AM
Hello,
does SZ-144 support tunnel mode wlans? Or do I need a separate dataplane node to use tunnel mode?
Solved! Go to Solution.
09-29-2023 12:50 AM
Hello @kessvn,
All hardware controllers comes with DP blade, you can tunnel the WLANs and start using it. While setting up SZ144, setup wizard prompts for One-Port group/Two-Port group. If you wish to isolate data traffic from control traffic, you could opt Two-Port group settings for better performance and user experience.
Regards,
Parik
09-29-2023 12:50 AM
Hello @kessvn,
All hardware controllers comes with DP blade, you can tunnel the WLANs and start using it. While setting up SZ144, setup wizard prompts for One-Port group/Two-Port group. If you wish to isolate data traffic from control traffic, you could opt Two-Port group settings for better performance and user experience.
Regards,
Parik
09-29-2023 12:56 AM
Hi @Parik_MN ,
Thanks!
Is there any information about SZ144 throughput? I believe it won't be able to fully utilize 4x10Gb ports at full speed.
09-29-2023 01:22 AM
Yes @kessvn, multiple ports are provided for redundancy setup. SZ can utilize one 10Gig interface at a time.
Regards,
Parik