11-11-2022 03:02 PM
R510 WAP is not working. It’s stuck in after few hours of working. Green turn to red light. Clears up after resetting. I have two units, one located on the first floor and second one is upstairs(slave unit). My slave is working fine. My switch box and other devices such as modem and router from the service provider is located upstairs,fyi. My slave was replaced two months ago and it appears to working so far.
please advise me for the next step.
Solved! Go to Solution.
11-11-2022 04:04 PM - edited 11-11-2022 04:32 PM
Hi @Indravadan
Thanks for the details provided, seems your AP is stuck in boot mode, and a factory reset is require, please follow up the next guide.
Physical Factory Reset, an Access Point Ruckus
How to factory reset or factory default different type of Ruckus Access points? Article
https://support.ruckuswireless.com/articles/000012418
Best regards,
Yarenis Hernández
Technical Support Engineer | L2 TAC Wired
11-11-2022 04:04 PM - edited 11-11-2022 04:32 PM
Hi @Indravadan
Thanks for the details provided, seems your AP is stuck in boot mode, and a factory reset is require, please follow up the next guide.
Physical Factory Reset, an Access Point Ruckus
How to factory reset or factory default different type of Ruckus Access points? Article
https://support.ruckuswireless.com/articles/000012418
Best regards,
Yarenis Hernández
Technical Support Engineer | L2 TAC Wired
11-14-2022 10:10 AM
Yes indeed, it appeared to be working. Factory reset instruction resolved the issue at this time.
thank you very much.
11-14-2022 10:21 AM
Hi @Indravadan
I am glad the issues have been resolved, please mark the post as SOLUTIONS ACCEPTED, and feel free to contact us again in the future.
Best regards,
Yarenis Hernández
Technical Support Engineer | L2 TAC Wired
11-14-2022 11:38 AM
Solution accepted