CommScope RUCKUS Community Forums

Indravadan · 11-22-2022

I had trouble with subjected device about four wks ago, stuck in red light. Recommended to do ‘ factory reset’ which I did but didn’t clear. Finally I unplug Ethernet cable from the switch and that helped cleared the red to green. However it is inte...

Indravadan · 11-11-2022

R510 WAP is not working. It’s stuck in after few hours of working. Green turn to red light. Clears up after resetting. I have two units, one located on the first floor and second one is upstairs(slave unit). My slave is working fine. My switch box an...

Indravadan · 11-22-2022

By the way this is a brand new house, everything is built in by the builder, fyi.

Indravadan · 11-22-2022

Yes, both end of the cable ends terminated with new connectors when I had problem with slave unit(2nd floor) back in the April. Slave unit was replaced with brand new and it’s working good without any trouble so far.Master unit( 1rst floor) having is...

Indravadan · 11-14-2022

Solution accepted

Indravadan · 11-14-2022

Yes indeed, it appeared to be working. Factory reset instruction resolved the issue at this time.thank you very much.

CommScope RUCKUS Community Forums

User Statistics

User Activity

Stuck in red light, fail mode.

WAP access point(master) R510 stuck in red

Re: Stuck in red light, fail mode.

Re: Stuck in red light, fail mode.

Re: WAP access point(master) R510 stuck in red

Re: WAP access point(master) R510 stuck in red