Ruckus switch not showing in the dashboard

[ra507102234]

Ruckus switch is not showing in the dashboard, does this mean the switch is not working ? Tried adding manually, but I am not sure of IP address. When I run the IP scanner, showing two AP IP's but not finding the Switch IP I guess. Any suggestion how to add switch to dash board first. Then I can continue debug the rest.

[Yarenis]

Hi @ra507102234 

Your Switch is running routing code and an old code 08080, you need to fix the routing code issue, after that may join however the next will be performing an upgrade to the code 08095g UFI.

1:Fixing the routing code issue:

ICX7150-C12 Router>enable   

ICX7150-C12 Router>show flash  (you can confirm in which partition you have the correct code that will start with SPS example: SPS08080f.bin normally will be your primary partition)

ICX7150-C12 Router#copy flash flash secondary  (this will copy what is in your primary code to the secondary)

ICX7150-C12 Router# write memory

ICX7150-C12 Router#show flash  (now both partitions must start with the SPS before the code type)

ICX7150-C12 Router#Boot system flash primary yes 

2:Configure SSH:

Switch(config)#configure terminal

Switch(config)#crypto key generate

Switch(config)#aaa authentication login default local

3:Upgrade recommended in case did not join

How to Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

How to upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

Best regards,

Yarenis Hernández.

Technical Support Engineer | L2 TAC Wired | Lennar Home Community

[ra507102234]

DOn't see *f anywhere :

telnet@ICX7150-C12-Router#show flash
Stack unit 1:
NAND Type: Micron NAND 2GiB (x 1)
Compressed Pri Code size = 31457280, Version:08.0.95gT211 (SPS08095g.bin)
Compressed Sec Code size = 31457280, Version:08.0.95gT211 (SPS08095g.bin)
Compressed Boot-Monitor Image size = 786432, Version:10.1.24T225
Code Flash Free Space = 1170251776

[Yarenis]

Hi @ra507102234 

I see you have upgraded the Switch, is the Switch still no showing in the Unleashed dashboard?

This was the version you have shared before.

Best regards,

Yarenis Hernández.

Technical Support Engineer | L2 TAC Wired | Lennar Home Community

[ra507102234]

I still don't see switch:

[ra507102234]

What next ?