cancel
Showing results for 
Search instead for 
Did you mean: 

Ruckus switch not showing in the dashboard

ra507102234
New Contributor III

Ruckus switch is not showing in the dashboard, does this mean the switch is not working ? Tried adding manually, but I am not sure of IP address. When I run the IP scanner, showing two AP IP's but not finding the Switch IP I guess. Any suggestion how to add switch to dash board first. Then I can continue debug the rest.

1 ACCEPTED SOLUTION

ra507102234
New Contributor III

It all worked atlast. Thanks a lot!

View solution in original post

29 REPLIES 29

Hi @ra507102234 

Take in consideration that the credentials you need to use, are the ones you created during the configuration, or the same you used when you gained access via telnet.

 

Best regards,

Yarenis Hernández.

Technical Support Engineer | L2 TAC Wired | Lennar Home Community

ra507102234
New Contributor III

I didn't have to give anything to gain access. Don't remember if I had changed this before. Anyway to reset this to what I wanted now ?

Good news. Switch is connected now. How do  I make sure things are in order ? 

Hi @ra507102234 

Great, 😎 you can test connectivity, however you should not have any issues.

 

Best regards,

Yarenis Hernández.

Technical Support Engineer | L2 TAC Wired | Lennar Home Community

ra507102234
New Contributor III

It all worked atlast. Thanks a lot!