cancel
Showing results for 
Search instead for 
Did you mean: 

Ruckus 7150 C12P showing not alive after hard restting.

Kamal1320
New Contributor

Hello Moderators.

I have Ruckus 7150 C12P when I purchased the house and am 2nd owner of this house. As previous owner disconnected all cables and wires from the switch, I try to connect and found not working. Try to reset with Pin at front of the switch and power off and on, but cannot found working. Then I try to hard reset by downloading all steps mentioned in forum. Finally found ping says not alive.

I am submit  pics of the results and connections. Please guide me .

ThanksIMG_0842.jpgIMG_0843.jpgIMG_0844.jpgIMG_0845.jpgIMG_0846.jpgIMG_0847.jpeg

1 ACCEPTED SOLUTION

Hi @Kamal1320 

Thank you for the response and the update.

Check 'Ports (COM & LPT) details (Refer to the screenshot)

If you don't see in COM & LPT details, check if you have installed the drivers of the Switch, if not please do. follow the below process.

Please make sure to download the zip drive for the file below & "extract all". Once it's extracted, run the file, the driver should be installed using the 2 links below.

Link 1: https://support.ruckuswireless.com/software/1414-brocade-ruckus-7150-usb-serial-driver-windows

image

image

 Link 2: silabs.com/developers/usb-to-uart-bridge-vcp-drivers?tab=downloads

image

Once done, please restart the Switch and the laptop, and unplug/plug the software recovery cables. 

Please check and let me know.

Thank you again. We appreciate your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

View solution in original post

21 REPLIES 21

Imran_ruckus
Moderator
Moderator

Hi @Kamal1320 

Greetings!!!

Thank you for reaching out to the RUCKUS Lennar Home Community. 

We appreciate your patience and understanding as we work to resolve the issues you are experiencing with your RUCKUS setup.

Based on the information provided, it appears that you are getting a ‘not live’ error during the RUCKUS ICX-7150-C12P Switch Software Recovery process.

This error is usually due to a firewall that is enabled on your Windows laptop.

Please refer to the below RUCKUS Lennar Knowledge Base self-help article to fix this issue.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Fixing-host-192-168-0-x-is-n...

Additionally, please make sure to use ethernet cable (both ends RJ45 plugs) and USB to type C cable both together as described in steps 2 & 3 in the guide link. (Refer to the below screenshots)

Please let me know if you need help at any point during the process and let me know if you have any queries in this regard.

Thank you again for your patience.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Kamal1320
New Contributor

Thanks Imran.

I did the window's firewall off as described by your tech Jaya in some thread. It says same not alive". I am posting  2 pics after firewall off.

Thanks

IMG_0851.jpgIMG_0852.jpg

Hi @Kamal1320 

Thank you for the response and the information.

Could you please share a picture showing the Software Recovery cable connections between the RUCKUS Switch and the laptop?

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Hello Imran ,

Sorry for the delay. Was away from pc. Please find attached pictures of the connections. There is no option for adding images.

Thanks