I factory reset my ruckus 7150. I have a sticker on it that gives from Lennar wifi name and password and admin name and password. The APs are now broadcasting Recover.me-xxxxx. I think I need to log into the AP and turn off mesh? What is the password? I tried ruckus-admin, ruckus-Lennar, the serial number, and ruckus-<serial number>. I can't figure out the password, is it based on the connected 7150 at all? I don't know what ruckus-<password> means when I read through this forum.
I'm not really sure how I got it working, but I did, ha. I configured it over my laptop and the WLAN I created finally showed up, and I see both APs and both are transmitting data. Whew. Thanks for the help and quick responses!
Since I reset the switch, do I have to log into it to configure the APs or can I set up the APs from the AP connection? Ap is still broadcasting recover.me and I can't get it. But I now have internet connection working.
Hi, thanks so much for your help. Small step closer to success. OK hard reset the AP and got to configure me. FYI, when I do the IP address https://www.advanced-ip-scanner.com/ I see that 192.168.1.4 is labeled at Ruckus Wireless and it is the MAC of my 7150. I dont actually see another Ruckuss device (shouldnt I see my AP?)
I connect to the Configure.Me-xxxx, and connect via the unleashed mobile app. I go through custom install
Automatic DHCP Master IP Address 192.168.0.1 (is this right?)
Mesh Option disabled
I set my new WLAN name, and WLAN password
Admin username and password ( I set this to my own admin password, should this be from the default that Lennar gave me, even though I reset the 7150? )
Set the recovery question and email, and then press submit.
I don't see the WLAN/SSID that I created. I still see Configure.me-xxxx not the WLAN I created. I did disable Private DNS. And now I can't connect to the Confiture.Me-xxxx that i had just used. What am I doing wrong? Am I supposed to use the admin creds for the 7150?