07-09-2023 05:38 PM - edited 07-09-2023 05:51 PM
Hi. My Ruckus ICX7150-C12 is booted with Router firmware and I cannot get it to flash to Switch firmware. I read all the post and tried to flash the primary firmware and it looks like file was corrupted. I saw instructions to download and overwrite the primary firmware here Solved: RUCKUS Forums - Re: Ruckus ICX 7150-C12P - Page 9 - CommScope RUCKUS Community Forums (rucku... but I received error code 5 when trying to download using below both commands:
copy tftp flash 10.176.220.51 SPS08095hufi.bin primary
copy tftp flash 10.176.220.51 SPS08080f.bin primary
Solved! Go to Solution.
07-10-2023 10:28 AM
Hi @LennerHelp
Greetings!!!
Thank you for the response and the information you shared.
This may be because your switch may be running on the Routing code (SPR). The Switch should run on the Switching code (SPS) to avoid these issues for Lennar home users. Due to a power outage/power spike, the Switch boots up on the other partition which may be running on a ‘Routing Code’ results in causing this issue.
As I can see from the output you shared, your Switch may be booted up on the secondary partition which is running on Routing code (SPR) as highlighted in the below screenshot.
Please Enter the below commands in CLI to fix this issue:
Note: Hit Enter to accept each command
enable
copy flash flash secondary
boot system flash secondary yes
Example:
VIDEO LINK AS REFERENCE: https://www.youtube.com/watch?v=Eem1IBgYaWc
ICX7150-24P Router>enable (hit enter to accept the command)
ICX7150-24P Router#copy flash flash secondary (hit enter to accept the command and wait: until the flash finished)
ICX7150-24P Router#boot system flash secondary yes (hit enter to accept the command: the switch will reboot)
Please check let me know if you have any queries in this regard.
Thank you again for your patience.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
07-10-2023 05:56 AM
Hi @LennerHelp
Greetings of the day,
Thanks for your detailed description.
To solve this issue please run the following commands on your command line 'CLI'
ICX7150-C12 Router>
Note: Hit Enter to accept each command
enable
copy flash flash secondary
boot system flash secondary yes
For example:
ICX7150-24P Router>enable (hit enter to accept the command)
ICX7150-24P Router#copy flash flash secondary (hit enter to accept the command and wait: until the flash finished )
ICX7150-24P Router#boot system flash secondary yes ( hit enter to accept the command : the switch will reboot )
How to Fix Routing code issues on Lennar Home users via CLI
Or WEB access option
Please share the screenshot of the error you are getting while following the steps.
Best regards,
Jayavidhya
Lennar Home Community
07-10-2023 07:10 AM
Wouldn’t flashing secondary just update the firmware to SPR(router) firmware and not switch firmware?
07-10-2023 07:43 AM
Hi @LennerHelp
Please share the screenshot of the error you are getting while following the process.
Also to check the switch status please share the output of the following commands.
Enable
Show version
Show flash
Please let us know if you have ay queries in this regard.
Best regards,
Jayavidhya
Lennar Home Community
07-10-2023 08:34 AM
it appears that I do not have permission to post image. Can you help provide permission?