12-02-2021 08:16 PM
Hi,
I would like to know if it is possible to use both interfaces
on a R720 Access Points while they are managed by
vSZ or ZoneDirector or Smart Zone 100.
We currently use eth1(PoE) managed by either one of the above controllers.
I would like to set up a static IP address
on the currently non used eth0 interface.
If this is possible, could you kindly give me a link
for a manual where this is explained?
TIA,
12-21-2021 09:49 PM
Thanks a lot for your support Vineet.
I am wondering if you had time to review my answer.
TIA,
12-22-2021 04:47 AM
The power mode looks correct. The client once connected should recieve an IP. Can you please open a TAC ticket adding these details to debug further.
https://support.ruckuswireless.com/contact-us
Best Regards
Vineet