R720 Using eth0 and eth1 at the same time

[Anonymous]

Hi,

I would like to know if it is possible to use both interfaces 
on a R720 Access Points while they are managed by 
vSZ or ZoneDirector or Smart Zone 100.

We currently use eth1(PoE) managed by either one of the above controllers.

I would like to set up a static IP address 
on the currently non used eth0 interface.

If this is possible, could you kindly give me a link 
for a manual where this is explained?

TIA,

[Anonymous]

@vineet_nejawala 

Thanks a lot for your support Vineet.

I am wondering if you had time to review my answer.

TIA,

[Vineet_nejwala]

@fred_ellena

The power mode looks correct. The client once connected should recieve an IP. Can you please open a TAC ticket adding these details to debug further.

https://support.ruckuswireless.com/contact-us

Best Regards

Vineet