My ICX 7150 is dropping internet connection constantly and after doing much research here and watching the Terry videos I’ve determined this is from not having the primary image available or corrupted and it reverts to secondary image ia “R” router image that is likely throwing all sorts of loops as I have an existing router connected to it.
Ive followed steps to TFTP a new image with uboot/update image articles with no luck.
can someone please share how I can copy the Image from usb? I was successful in copying config from usb automatically after doing clear-config, but primary image isn’t copied.
can uboot be pointed to USB image path instead of tftp IP?
Even if it boots to router code, the ICX will still switch packets just the same. It just changes what options are available in the CLI (Layer 3 interfaces, routing, etc.). Something would have to be manually configured to interfere. I believe the Lennar deployments are just one flat vlan. You can surely run on the router code and the default configuration is just one vlan. In this case, we would basically act the same way whether we are on switching or routing code.
Are you able to console to the switch?
Are you stuck in the boot monitor? The prompt would look something like this if you are: