Looking for better wifi proformance

[Homeowner13]

Currently running Ruckus ICX 7150 c12p switch and 2 Ruckus r510 APs. I am looking to get some better proformance as it feels laggy and connections seems to drop. Also ISP is at&t download is about 480 megs. I updated switch firmware to latest version and APs are also at latest version. Any other suggestions would be greatly appreciated. 

Homeowner

[pinky_ruckus]

Hello @Homeowner13 ,

Thank you for sharing the response.

From the below screenshot you shared, I understand that the Switch is booted up on the secondary partition which is running on Routing code (SPR)

The Switch should run on the Switching code (SPS) to avoid these issues for Lennar home users. Due to a power outage/power spike, the Switch boots up on the other partition which may be running on a ‘Routing Code’ results in causing this issue.

Please follow the below RUCKUS Lennar Knowledge base self-help article which will help you to fix the issue when the Switch is running in the Routing code.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Fixing-RUCKUS-ICX-7150-C12P-...

Please follow the process as explained in the article and let me know if you have any queries in this regard. 

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[Homeowner13]

[pinky_ruckus]

Hello @Homeowner13 ,

Thank you for the response.

It should actually boot on the Primary partition.

However, due to a power outage/spike ; the Switch boots up on the other partition, secondary partition; which may be running on a ‘Routing Code’ results in causing this issue.

Please follow the below RUCKUS Lennar Knowledge base self-help article which will help you to fix the issue when the Switch is running in the Routing code.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Fixing-RUCKUS-ICX-7150-C12P-...

Please follow the process as explained in the article and let me know if you have any queries in this regard. 

Thank you again for your patience and understanding.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community.

[Homeowner13]

Hello Pinky

Hope all is well. I would I know if it is running on primary? Thank you for you patience 

[pinky_ruckus]

Hello @Homeowner13 ,

Thank you for the response.

I understand that you are looking to see if it is running on Primary or Secondary partition.

 

From the above screenshot, If the label reads "Primary," it will be located on the Primary partition. If it is labeled "Secondary," it will be on the Secondary partition. This can be obtained by checking the output of the show version command

Please let us know if you have any queries in this regard.

Thank you for your patience and understanding.

Regards,

Pinky Rajendran

RUCKUS Lennar Home Community.