ICX 7150-C12P Software Recovery times out when running the update commands to relaod images

RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.

You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.

Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.

I've got the dreaded "won't-come-back-up-following-a-power-outage" issue, where I've been following the instructions to recover the software via https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-a-Software-re...

All aspects of the connectivity are fine. I am able to set IP addresses, and connect in.

Where this all fails is when running the three "update" commands, i.e. "update_primary", "update_secondary" and "update_uboot"

Although I have successful PING to my PC, when executing the updates, I see a series of "T" characters gradually spread across the screen, then I get a timeout message, with the suggestion that it is retrying, but immediately returns me to a command prompt.

I'm assuming therefore that the images are therefore corrupted? Please advise.

Thank you.

3 REPLIES 3