12-20-2022 07:16 AM
It looks like I am another customer dealing with issues after power outage. We've had this Lennar home for a couple of years and after every power outage we have to go through a reboot. This time however after several attempts to reboot, the system will not reboot and we have no power, no lights at all, going to either access point. To say this system in our "Smart Home" is aggravating is an understatement.
12-20-2022 08:19 AM
Hi @RCK
Basically, due the power outage/ power spike the switch went to a state that we called (boot-mode) that is not able to boot up properly.
That does not mean is broken or need to be replace 'in some cases'
1-Please try to disconnect from the Power outlet the ICX-7150 and reconnected.
2-Please try to press the reset button using a paper click or a small stick
Video link:https://www.youtube.com/watch?v=6jHMTdo_hK4
If that does not make any difference, we need to perform a software recovery since it can be that the image flash is corrupted so in basic words the unit is not able to boot up properly and need re-install the image to boot up properly.
3-We need to access (physical) using one of the cables to the ICX-7150C12P mentioned on the below guide:
How to console in the ICX-7150-12CP
Once we are there, we can try to boot up the unit using the following commands:
Boot_primary or Boot_secondary
If that step does not work Software recovery needs to be applied
Here is the guide how to do it :
Video Link: https://www.youtube.com/watch?v=Ql22blH_CGo
Best Regards
Fernando Vasquez
12-20-2022 07:55 AM
S/n FEK3825Q2D3
12-20-2022 07:56 AM
It is in a control panel and everything inside panel has power.