cancel
Showing results for 
Search instead for 
Did you mean: 

Firmware Upgrade for ICX7150-C12 Switch - Need help locating Firmware version and help upgrading

MiSNemesis
New Contributor

I have a ICX 7150 since 2020 and was never upgraded.  I am at a lost as to how to locate the version and then what upgrade is necessary to use.  Any help would be appreciated.

1 ACCEPTED SOLUTION

Jayavidhya
Moderator
Moderator

Hi @MiSNemesis 

 

The recommended firmware version for ICX 7150 Switch is SPS08095dufi.bin 

 

Please follow the below guides to perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin to avoid the issues in future.

 

1.Upgrade a Switch ICX-7150-C12P using a USB flash drive

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

2. Upgrade a Switch ICX7150-C12P via TFTP

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-Upgrade-a-Switch-ICX-...

 

3. Upgrade a switch via Web GUI (ICX7150 Switch)

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-perform-an-Upgrade-vi...

 

 

Please let us know if you have any queries in this regard.

 

Best regards,

Jayavidhya

Lennar Home Community

View solution in original post

36 REPLIES 36

Hi @MiSNemesis 

Thank you for the response and the update.

Could you please check connecting other working ethernet cables from the Switch to the Access Points? In case current Access Point ethernet cables are damaged.

Please check and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Not sure how I am going to accomplish that.  Those cables go through the whole house.  I can't push another cable to the APs easily.

Hi @MiSNemesis 

Thank you for the response.

You could unmount the Access Point from the ceiling and check with a spare working ethernet cable if you have one.

Apologies for the inconvenience caused.

Please check and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Ok I tried a new cable to the upstairs AP and still no lights on switch or ap

Hi @MiSNemesis 

Thank you for the response and the information you shared.

Could you please share the output of the below commands?

enable 

show flash

show inline power 
show interface brief

Thank you again for your patience.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.