Access points no power

[Jevytsee168]

My access points do not have power 

[Jevytsee168 · Accepted solution]

 

 

[guylucero]

What did you find out?

[Imran_ruckus]

Hi @guylucero 

Greetings!!!

Thank you for contacting RUCKUS Lennar Home Community.

Hope you are doing well.

As this case is raised by @Jevytsee168 which is now closed.

To avoid confusion with posts, you can create your own post on this RUCKUS Lennar Community forum with the problem you're facing and a detailed description of the network issue and what you've done so that we can guide you properly.

Thank you again for understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

[Jevytsee168]

It wont allow me to send picture. Something is exceeded. The devices on the ceiling does not have any power. I plugged the wire from the router/wifi from frontier and showing a blinking green on the ruckus on the wall. However the devices on the ceiling both do not have power. What to do next? 

[Jayavidhya]

Hi @Jevytsee168 

Thanks for the images,

Please let us know whether you have tried accessing your switch CLI and entered the commands mentioned in the above posts.

If not please try to take access to the switch using the two ways and enter the following commands.

enable

Show version

Show inline power

Show inline power detail

Once you have done with the above process please share the output of the commands.

Please let us know if you have any queries in this regard.

Best regards,

Jayavidhya

Lennar Home Community