I recently changed the boot sequence from primary to secondary in config mode. I am now unable to put it back to primary . When I try to change it back I get an error message " error-boot sequence has reached max 1 entries".Any suggestions on how to ...
I am new to managed switches. I need to configure a ICX7150-24P to have 9 Virtual LANs or Subnets. These are:VLAN 1 - ManagementVLAN 10 Computers (with 4 Ports Dedicated to 4 rooms hardwired in the house)VLAN 20 Work Computers (with 1 dedicated ICX P...
Hi, On a ICX7250 switch, using SecureCRT/Putty , and a micro usb - serial cable, I have a "acces denied" displayed on my session ? Is it possible to unlock this console port?
Hi thereI've stumbled across following log entry on one of our ICX7450-24 (running 08.0.90mcT213):N:TCP: Local TCP exceeds 100 burst packets, stopping for 10 seconds!!This is a single event that just popped up. My research wasn't really successful. D...
I have an ICX7150-C12P that isn’t booting properly. When I connect to it via the serial console, I get errors like:"ZQ calibration error (P offset) - Manual IO programming required for correct operation""Validate Shmoo parameters stored in flash .......
