RUCKUS ICX Switch Family

|

ICX Switches

The RUCKUS ICX® Campus Switch family delivers a complete, scalable, and high-performance routing and switching solution that supports today’s demanding network applications.

Forum Posts

Sorted by:

ASK the Pack

ICX-7150-C12 static IP interface disappears from the network after 25 seconds after boot completes

I have an ICX 7150 C12 which has been running fine for over 2 years on 8.0.9. Today I added an SPF+ RJ45 module to on of the uplink ports to see if I could use it to connect with my router, it didn't, of course, so i pulled the module out and reconn...

Resolved! Applying a licence to a switch stack

I'm fairly new to networking so I apologize if this is fairly obvious. I googled, but I was unsuccessful/confused.We recently received new ICX7400 switches. I consoled into each one and upgraded the firmware to 08090k and applied licenses to each. We...

Disabling status-server (Code field 12) on a ruckus icx 7450 switch

I've got a Wired 802.1x implementation with a ruckus switch as the Radius client and a Microsoft NPS acting as the Radius server.The below config line on the switch is the one causing me a lot of grief and I see a constant error showing up on Event V...

Resolved! UPLINK termination to the stack members and roles

We are planning build a new ICX7450 stack with 4 members, and will have two 10G UPLINKs to our core network.These 10G connection will be terminated to module 2 (eth1/2/x) in different unit for physical redundancy.My question here is to which unit we ...

Resolved! Loop detection on access switch before core switch shuts down the uplinks

Dears,I'm running into a problem where i have a setup of several access cabinets connected via a star topology to core switch, access switches are icx 7150 and 7250 and core is 2 stacked 7650. We configured loose mode loop protection on all of the ac...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

1