Have a network where there is an 11g bridge that needs to go. Awaiting SmartMesh on the T300 to solve the issue. as the 11g bridge is bottlenecking everything on the far side.
Hello,
I'm relatively new to ruckus gear.
We have 30 zf7982s in 3 non-overlapping areas.
The short version is that i'm only getting 11g speeds even when clients connect at 11n (2.4 or 5ghz).
I've taken an ap and restricted it to 11n mode but that...
I've noticed that SmartMesh support is curiously lacking from the R500/R600 data sheets. Am I reading too far between the lines that unlike the T300's and R700's, the R500/R600 will not support meshing?
Hi Everyone,
As a preface, I worked with Ruckus support directly on this issue and the tech stated that my configuration looks correct and it might be the AP, but I am having this issue on another AP as well.
In short, when attempting to connect to...
I tested some APs to know the functionality of the PT port i.e 7055 & 7025; & I learnt how it works. Although i was wondering if the Pass-through port could be used as a solution for a down AP.
Thing is: In my network, the previous config was:
PoE ...