RUCKUS Indoor and Outdoor Access Points (APs)

|

Access Points - Indoor and Outdoor

RUCKUS Indoor, Outdoor, Bridge and Specialty Wi-Fi Access Points (APs)

Forum Posts

Sorted by:

ASK the Pack

ZoneFlex 7055 Problem; WAN is blinking green light, please help me troubleshoot.

ZoneFlex 7055 Access Point, PWR led is steady flashing green;WAN led is flashing blinking green light , this is my problem.5g , 2.4g, AIR, DIR led have no light.* I have done soft and hard reset multiple times and plugging it again to the switch hub...

vSZ configure User Role via RADIUS Attribute

Hi everyone, I'm currently trialling Ruckus vSZ 3.6.2.0.222 with an R510 and R710 AP. I'm attempting to set up a single SSID (eduroam) for both internal devices authenticating via EAP-TLS and BYOD devices using PEAP. Depending on which rule is trigge...

Better AP for my home

Hello, I ask you for advice on which is the best AP for my home. My house is 10mtx10mt, on 2 floors. The AP would be placed in the center of the ground floor, at the top, almost at the edge of the ceiling. About 40 wireless devices will be connected ...

Setting up Asus RT-N12HP Router as a Wireless Repeater

Unable to setup Asus RT-N12HP Router as a Wireless Repeater for a Leashed Ruckus Indoor AP.- Asus router has been marked as known at the "Known/Recognized Rogue Devices" category.- Getting an error message "Unable to get IP address" when connecting t...

Unable to enable Ethernet Port1 on R730 standalone

Configuration >> Ethernet Ports >> Enabling Port 1 shows parameters saved, but still the check box is unchecked.

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

1

1

1

1

1