04-12-2021 11:58 AM
I have T610S AP that I'm using it for testing purpose
I pointed to SmartZone by but I forgot the default credential or I may have changed the default credentials when i ssh to it
now I'm trying to reset to factory default but by SSH to it from the switch the provide POE but no luck so far
any suggestion here on how to reset to factory default so I can log in to it using 192.168.0.1 and default credential ?
I know R310 it has a reset button that you can push and hold but T610 doesn't have that button
thanks in advanced
04-13-2021 01:21 AM
The T610 does have a reset button.
The information above is taken from the T610 Quick Setup Guide.
Hope this helps!
04-13-2021 06:56 AM
@sam_evans thank you for your respond
I have tried all these steps but the default credenatl user/password "super/sp-admin" wont work
not sure if there is any other credential that I could try it
04-13-2021 07:52 AM
Isolate the AP from the network on which the SmartZone is, also from DHCP if the goal is to use the APs default IP address. The initiate the FD procedure (Press and hold the reset button for 15 seconds). This should then put the AP into a factory default state. It might be that the AP is rejoining the SZ if you do not have it isolated.
The credentials for APs will have been set in the SmartZone. You can easily change these from the SZ GUI under the Zone for which the AP resides:
Hope this helps,
04-13-2021 08:46 PM
thank you, Sam, appreciate it
yes it did help and it worked, the issue was the AP still managed by the controller even after I reseted twice so it could be the reset didn't take first couple of time