We have a couple of these deployed supporting the R760 which is uplinked at 2.5Gbps. Currently all APs are reporting that they are only connected to a 802.3at capable switch. The datasheet for the ICX 7150 states that the 7150-C10ZP has 4x 802.3bt ...
I've been following the old Smartzone Network-Design-with-NAT guide and something I'm trying to wrap my head around is the AP Connection behaviour when both internal and NAT addresses are reachable.Preferably, we'd like to have new APs out of the box...
Is the Ruckus Bonjour Gateway implemented on APs only applicable to VLANs actively used by other WLANs configured on the AP?I'm trying to understand if an AP connected to a trunk port setup with a Bonjour Gateway policy, can act as a bonjour gateway ...
We just upgraded from 6.1 to 6.1.1 last night and this button seems to be missing from the AP -> Health airtime graph. The pie chart it opened up was really useful for determining if an AP was having high CCA/Utilization just from itself being busy ...
I'm looking through the documentation below trying to figure out if once we configure TACACS+, will the local accounts still be usable?https://docs.commscope.com/bundle/sz-611-adminguide-sz100vsz/page/GUID-B9789B57-C58B-4215-A83A-AC05BA1458C4.htmlFor...
Thanks Sunny,Its odd that the spec sheet says there are 4 full 802.3bt ports but the install guide only mentions two. I'll report back here if we find out that those C1 and C2 ports are also .3bt capable.
Hi @zoneMedicOrches , I came here looking for answers to the same question. It seems odd that they would pull back in hardware specs from the R760 to the R770, I wonder if 4x4 on 6GHz is being moved to the R8xx series. Did you find a more thorough ...
Hi Bruno,Is it at all possible ruckus might backport the R770 support to SZ v6.1.2? We have a fairly large deployment and would like to start adding some R770s but the SZ v7.0 requirement is a showstopper for us until it goes stable.
