CommScope RUCKUS Community Forums

mrmadgig · 10-15-2022

Hello CommunityI have a simple question that I tried to locate before posting. I have two ICX 7150's and one does not show the interfaces when issuing the show run or show config command See below password-change anycdp runsnmp-server enable traps h...

mrmadgig · 03-22-2021

Hello Looking to see if anyone has the answer to this? I have a R710 connected to a ZD1200 and I want to change the network ports on the AP one as trunk (which it is be default) and the other one an to an access port to set a native VLAN on the seco...

mrmadgig · 10-26-2022

Thanks didn't expect this behavior as one would think that you would want to see your interfaces as the most important in a switch. However thanks this helped me understand the issue.

mrmadgig · 10-21-2022

Yea I see. Thank you.

mrmadgig · 10-21-2022

HI Thanks for the replyI learned that if you do not configure somehting on the interface itself it will not show in the run config.That is really stupid. So both switches do the same thing. I running the recommended version.Thanks

mrmadgig · 10-15-2022

I also reset this to factory and upgraded to the recommended version and no success.

mrmadgig · 10-15-2022

Thanks for the replyHowever this is not the case with this switch. This switch is in production and has a config on each interface.It will show the interfaces on the commands show int br and show interfaces and show interface x/x/xSSH@ICX7150-C12 Swi...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Ruckus ICX Switch not showing interfaces in show run

NIC Ports on the AP's

Re: Ruckus ICX Switch not showing interfaces in show run

Re: Ruckus ICX Switch not showing interfaces in show run

Re: Ruckus ICX Switch not showing interfaces in show run

Re: Ruckus ICX Switch not showing interfaces in show run

Re: Ruckus ICX Switch not showing interfaces in show run