Ruckus ICX Switch not showing interfaces in show run

[mrmadgig]

Hello Community

I have a simple question that I tried to locate before posting. 

I have two ICX 7150's and one does not show the interfaces when issuing the show run or show config command

See below 

password-change any
cdp run
snmp-server enable traps holddown-time 30
snmp-server host 10.10.111.238 version v2c .....
!
!
clock timezone us Eastern
!
!
ntp
server time.google.com
!
!
web-management https
!
!
manager registrar
!
!
!
!
!
!
!
ip ssh timeout 30
ip ssh idle-time 30
!
!
!
!
!
end
SSH@ICX7150-C12 Switch#
SSH@ICX7150-C12 Switch#
SSH@ICX7150-C12 Switch#
SSH@ICX7150-C12 Switch#

Second switch shows the full config these are partialy sanitized

web-management https
banner motd ^C
Brocade 10 Port MGIG SWITCH ^C
!
banner incoming ^C
Brocade 10 Port MGIG SWITCH ^C
!
!
!
manager registrar
!
manager port-list 987
!
!
interface ethernet 1/1/1
inline power overdrive
!
interface ethernet 1/1/2
inline power overdrive
!
interface ethernet 1/1/3
inline power overdrive
!
interface ethernet 1/1/4
port-name
inline power overdrive
!
interface ethernet 1/1/5
inline power overdrive
!
interface ethernet 1/1/6
port-name
inline power overdrive
!
interface ethernet 1/1/7
port-name
!
interface ethernet 1/1/8
inline power power-by-class 4
!
interface ethernet 1/2/1
port-name
inline power overdrive
!
interface ethernet 1/2/2
port-name
inline power overdrive
!
interface ethernet 1/3/1
port-name
!
interface ethernet 1/3/2
port-name

Thank you

[mrmadgig]

I also reset this to factory and upgraded to the recommended version and no success.

[Chandini]

For the second switch the inline command looks like a global command from below link 

https://docs.commscope.com/bundle/fastiron-08080-commandref/page/GUID-A7542501-72A6-45E8-87F2-EC8B01...

try giving 

ICX(config)#no inline power overdrive

and try running "show run" and check 

Also what is the current firmware version you are running on both switches ? 

[mrmadgig]

HI Thanks for the reply

I learned that if you do not configure somehting on the interface itself it will not show in the run config.

That is really stupid. So both switches do the same thing. I running the recommended version.

Thanks 

[BenBeck]

You can issue something like 'show interfaces brief' or 'show interfaces eth 1/1/1' to see information on the interfaces.

[mrmadgig]

Yea I see. Thank you.