Hi Shubham,Radius access reject indicates 802.1x authentication failure.You will need to check the server side event viewer logs to find the root cause.Also, do refer the below support article for basic 802.1x troubleshooting:https://support.ruckuswi...
Hi @DAOHUUSANG ,If you are referring to the total number of clients supported in the R550 AP then it would be up to 512 Clients.Refer datasheet: https://webresources.ruckuswireless.com/datasheets/r550/ds-ruckus-r550.pdfRegards,Simon Louis
Hi @kramnitsuj,You can configure vendor specific attributes for accounting and authentication in v/SZ. Go to services >> Vendor specific attributes.For radius attributes refer to the below guide:https://support.ruckuswireless.com/documents/4075-smart...
Hi Adam,Please run the command get macdb <ifname>.Example: get macdb eth3This will show the mac-address that is learned on the particular eth port.Regards,Simon Louis
Hi @NoiseUnit ,Is this a vSZ-E or vSZ-H?If you are using vSZ-H please check if the AP is present under staging zone?Could you please share the output of get scg and get rpki-cert issuer from the AP CLI?On the vSZ do verify if you have any AP registra...
