I am wanting all my access points to get an IP from my DHCP Server which is being done at the switch level. I am using a /24 subnet, lets say 10.10.10.0/24. On my vSZ I have a few DHCP Pools set up depending what WLAN the clients connect to. Lets say...
I am not able to get my R550 to pick up the right IP settings... On my switch I am doing DHCP Services. Lets say VLAN 100 with IP Addresses of 10.100.0.0-10.100.0.254.Ideally, I want the R550 to get an IP Address in the VLAN 100 range and then give t...
I have a set of P300s I am deploying as a point to point pair. They are set as the main and remote. The IP is a /30 IP. I have multiple VLANs I want to pass across the link, but I am not sure if there is anything special I need to do. On my switch at...
Hello,
I am running a vSZ and R550s. They are all up to date.
I have a WLAN that I am working on for Corporate Owned Mobile Devices, basically company phones that come and go. We want this to be isolated from the share resources and basically o...
Hello,
I have two WLANs in my zone. One for our employees and one for guests/ employee mobile devices.
We wanted to have a Guest WLAN that was isolated and we wanted mobile devices on it as well. The issue I am having is that when people are no...
The issue was with DNS, I had created a DNS Profile thinking that was it, but still had the same issue after making it. I totally forgot about the DNS setting in the DHCP Pool configuration. After I made the change there (added my local DNS Server) i...
The one part I am having trouble figuring out still is this, I have a Virtual Machine running on VCenter that I want to be able to access, but not anything else. When I make my policy, I would have to make rules to allow me to get to the IP of VCente...
I guess what I am trying to figure out is
1) Do I NEED to use the source/ destination ports?
2) Source IP: Is this the Network ID/ Subnet or the device IP and Subnet?
3) Destination IP: Destination IP/ Subnet of Server I am trying to get to?
Ok, that is what I was starting to think...
I do have a question though, I am using a Virtual SmartZone, On the L3 Access Control, can I do a range of IPs? or would this have to be a 1:1?
