12-26-2023 07:17 PM
I have some R500s, firmware is 200.7, and two R610s firmware is 200.7 too.
Any possible to do that:
1. I prefer to set two R610s as unleashed master, r610-1 for master , r610-2 for master backup. when r610-1 failed, the r610-2 will take over the master role.
2. R500 as unleashed member
3. The max number of R500s will overcome the 25 limit
Solved! Go to Solution.
12-27-2023 07:02 AM
Hi @zlinuxboy,
You can set the preferred master in 200.7 but I do not think second master preference option is available in 200.7.
R500 and R610s can work together in single Unleashed network as both are supported in 200.7.
Refer the below path in Unleashed to configure preferred master.
Also, you can use up-to 50* APs in Unleashed 200.7 version.
For more information please refer to the Unleashed 200.7 admin Guide.
01-04-2024 06:53 AM
Hi @zlinuxboy,
Please confirm if you have any additional queries. If not, could you please accept the previous reply as a accepted solution, to complete this thread.
12-27-2023 07:02 AM
Hi @zlinuxboy,
You can set the preferred master in 200.7 but I do not think second master preference option is available in 200.7.
R500 and R610s can work together in single Unleashed network as both are supported in 200.7.
Refer the below path in Unleashed to configure preferred master.
Also, you can use up-to 50* APs in Unleashed 200.7 version.
For more information please refer to the Unleashed 200.7 admin Guide.
12-27-2023 05:09 PM
Thanks for clarification
01-04-2024 06:53 AM
Hi @zlinuxboy,
Please confirm if you have any additional queries. If not, could you please accept the previous reply as a accepted solution, to complete this thread.
12-28-2023 12:30 AM
Another question, the "zero-it and dpsk" is missing under wlan creation tab.here is the screen
My ap is r600 running 200.7.10.202.145 unleashed. any idea?