Deployment of new wifi on all Ruckus access points

[mohammed]

Hello,

I have a local wifi network consisting of 6 Ruckus access points, 4 R320s and 2 R310s with firmware Version 200.7.10.202.121. I have only one VLAN on my network. When I create a new wifi, it remains visible on the master terminal but not on all access points. I restarted the access points but that doesn't change anything. Do you have any idea about this problem? is this a sync issue between access points? how to correct it? 

[syamantakomer · Accepted solution]

Hello @mohammed,

Could you check below details and provide additional information?

1. Make sure that other APs (other than master) are connected and online in the master.
2. Check if you are using AP groups. If yes, you must configure WLAN to broadcast on specific/all groups (if APs are part of different groups). Refer the page 193 in Unleashed 200.7 user guide.
3. Login into member AP CLI using a terminal application like putty, etc. Run "get wlanlist" "get director" commands and share the output.