Hi everyone. I am new on Ruckus community and I am having problem to access web interface of my smartzone 100 controller. After a reboot I cant get access web page. SSH access is working normally. When I access the controller through ssh port i see that all services are down ("# show service" command). I already tried to UP services with the command "# service start" but even after several hours the session still shows me the following information: "Wait for (list of services) up. This list of services decreases right after the start of execution of command but then remains unchanged or even increases (as can be seen in the attached image). Looks like some service can't startup.
Is it possible that the controller is in some kind of "Maintenance Mode"? If so, is there a command to take the controller out of maintenance mode? Is there any other command I can run to know what is going on with the controller? Thank you very much for any help.
Looks like either the SZ went into "Crash mode" or "Maintenance mode" . The clearing of the controller from "Crash mode" or "Maintenance mode" can only be done through shell mode to which Ruckus engineer's have access. Kindly log a case with Ruckus so that we can clear the status on the controller and bring all services back online.
You can open a case either by online using below link and filling your details: