cancel
Showing results for 
Search instead for 
Did you mean: 

Signature pack exceeds maximum filesize

steve_kersley
New Contributor II

I'm preparing to upgrade our SZ100 from 3.6.1 to 5.2.1 which appears to be a supported upgrade path according to the upgrade guide.

Instructions on the 5.2.1 download page say: "Before upgrading SZ100 to 5.2.1.0.515 (GA), update to the Application Recognition and Control v1.470.1 signature package file"

However, if I try to install that signature package to the current system, it errors with 'The file size (9.7MB) cannot exceed the maximum size (2.0MB)

I can't see any file size settings, so presumably it's a hard coded limit.  So how do I install the signature pack before I upgrade the firmware?  Can I ignore that and install the signature pack afterwards?  The upgrade guide suggests not.

Do I need to go through any interim versions, and if so which ones? (again, upgrade guide says direct upgrade from 3.6.1 to 5.2 is supported)

6 REPLIES 6

eizens_putnins
Valued Contributor II

First thing, you must upgrade from 3.6.1 to latest 3.6.2, and than upgrade to 5.2.x.

second, I suppose mentioned remark is valid when you upgrade from 5.0 to 5.2, as 3.6 has different signature file format and size...

I can see that 5.2.2 wants a minimum of 3.6.2 (and I'm not going to upgrade straight to a just-released-yesterday version!), but the upgrade guide for 5.2.1 states:

"Upgrade from SZ versions 3.6.0, 3.6.1, 3.6.2, 5.1.0, 5.1.1, 5.1.2, 5.2.1 directly to 5.2 is supported."

syamantakomer
Community Admin
Community Admin

Hi Steve,

You can upgrade to 5.2.1 directly from 3.6.1.

https://support.ruckuswireless.com/software_terms_and_conditions/2566-smartzone-5-2-1-0-515-ga-sigpa...

Make sure image size and image MD5 is matching before you upload and apply.

File Name:RuckusSigPack-v2-1.470.1.ta...File Size:9.74 MBMD5 Checksum:a6166930e50ec46567d49593eebe0e98


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

federico_carbo1
New Contributor

Hi,

I'm having the same issue trying to upgrade from 3.6.2.0.250 to 5.2.2.0.317, when I try to upload the SigPack it shows 'The file size (9.7MB) cannot exceed the maximum size (2.0MB)'.

Is there any solution to this?

Best regards,

FC