Add T310 to Ruckus Virtual SmartZone Controller

[luke_blundell]

Hi,

I am trying to convert the Ruckus T310 AP to join our managed smartzone controller. I have done this for our R310/R510 numerous times withou any issues but the putty commands don't appear to be the same or work.

I feel it needs a particular software install on it to work but I can't seem to find it or if its even possible!

Any help would be greatly appreciated.

Thanks

[Vineet_nejwala]

Hi Luke,

Can you share the screenshot of the command you are executing on this AP CLI and the output of "get version" from this AP.

Best Regards

Vineet

[luke_blundell]

@vineet_nejawala Hi Vineet,

Thanks for the quick reply.

I have tried quite a few commands including:

set scg enable - not recognised

get scg - not recognised

enable - works

ap-mode - works

set scg ip: - not recognised

[Ratnadeep]

@luke_blundell

Hi Luke,

Yes, it's on Unleashed version. Please upgrade the AP to any Solo version from the below URL:

https://support.ruckuswireless.com/software?filter=64#sort=relevancy&f:@source=[Software%20Downloads...

Please refer to the below KB to upgrade the AP from CLI:

https://support.ruckuswireless.com/articles/000001551 

Regards,

Ratnadeep

[Vineet_nejwala]

Luke, the AP is in Unleashed code and hence the difference in CLI pattern. I am adding below an article  to convert such Unleash code AP to standalone and second link to download the standalone image that is compatible with SZ.

https://support.ruckuswireless.com/articles/000005193

https://support.ruckuswireless.com/software/1589-zoneflex-t310-series-outdoor-ap-108-0-0-0-771-ga-so...

Best Regards

Vineet