05-08-2025 10:25 AM
05-09-2025 12:47 PM
Hello @junjang ,
Thank you for the response.
From the screenshots you shared, I see that the PoE is disabled on your Ruckus ICX-7150 Switch.

To fix this issue and enable the PoE on the Switch, please perform the commands on the CLI:
Switch>enable
No password has been assigned yet...
Switch#configure terminal
Switch(config)#interface ethernet 1/1/1 to 1/1/12
Switch(config-mif-1/1/1-1/1/12)#inline power
Once you perform the above commands, all ports should be On, and Access points should get the power.
Once the RUCKUS ICX-7150-C12P switch ports come online, it should fix the issue.
Please let us know if you have any queries in this regard.
Thank you for your patience and understanding.
Regards,
Pinky Rajendran
RUCKUS Lennar Home Community
05-09-2025 10:32 AM
Hello @junjang ,
Thank you for the response.
Please be informed that the Ruckus Switch will be identified by the name of Ruckus Wireless or Brocade Communications.
Could you please use the same IP address to login to the web browser and confirm if you are able to access the Switch dashboard?
You should observe the Switch Dashboard, which should be visible upon accessing the appropriate IP address, as illustrated in the screenshot below.

Please let us know if you are able to access the dashboard with the obtained IP address.
Please login to the Switch dashboard using the default credentials.
Switch default credentials will be as mentioned below.
Username: super
Password: sp-admin
If the above credentials don’t work, you can try the default credential combinations below as well.

These usernames and passwords are key sensitive, please use capital letters where necessary.
If you are able to login successfully with the credentials, you may use the same IP address to Access the CLI of the Switch
Please let me know if you have any queries in this regard.
Thank you again for your patience.
Best regards,
Pinky Rajendran
RUCKUS Lennar Home Community.
05-09-2025 11:39 AM
Here are the outputs of the command
05-09-2025 12:47 PM
Hello @junjang ,
Thank you for the response.
From the screenshots you shared, I see that the PoE is disabled on your Ruckus ICX-7150 Switch.

To fix this issue and enable the PoE on the Switch, please perform the commands on the CLI:
Switch>enable
No password has been assigned yet...
Switch#configure terminal
Switch(config)#interface ethernet 1/1/1 to 1/1/12
Switch(config-mif-1/1/1-1/1/12)#inline power
Once you perform the above commands, all ports should be On, and Access points should get the power.
Once the RUCKUS ICX-7150-C12P switch ports come online, it should fix the issue.
Please let us know if you have any queries in this regard.
Thank you for your patience and understanding.
Regards,
Pinky Rajendran
RUCKUS Lennar Home Community
05-10-2025 05:59 AM
Thanks . This resolved the issue.
05-12-2025 06:20 AM
Hello @junjang ,
Thank you for sharing the response.
We are glad to know that the issue is resolved, and all the devices are back online.
Thank you for your patience and understanding.
Best regards,
Pinky Rajendran
RUCKUS Lennar Home Community.
