Upgrade ICX7150-C12 switch

[dazart]

I am trying to upgrade my ICX7150-C12 switch. I'm running SW: Version 08.0.80dT211 labeled as SPS08080d.

I found this post - https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Re-Upgrade-ICX7150-C12-to-la...

and followed the instructions to install the upgrade tool and documentation.  The upgrade tool gets to "Start writing image into Switch: Primary partition..." but doesn't get any further than 20% and fails with the message "Unable to upload upgrade image to primary partition".

[dazart]

Hello - I haven’t been able to upgrade the router yet. I’ll let you know when I get a chance.

Sorry for the delay.

[Imran_ruckus]

Hi @dazart 

Greetings!

Thank you for reaching out to the RUCKUS Community Forums.

As this case/post has been closed due to no response after our follow-ups, we kindly request you to raise a new post so we can assist you further.

Thank you again for your understanding.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support

[Imran_ruckus]

Hi @dazart 

Greetings!

Thank you for reaching out to the RUCKUS Community Forums.

As this case/post has been closed due to no response after our follow-ups, we kindly request you to raise a new post so we can assist you further.

Thank you again for your understanding.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support

[pinky_ruckus]

Hi 

Greetings! 

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it. 

If we do not receive a response from you within 24 hours from the timestamp of this message, your case will proceed to closure.

Thank you.

Best regards,

Pinky Rajendran

RUCKUS Lennar Home Community