Showing results for 
Search instead for 
Did you mean: 

Ruskus router is not working and access points not workin

New Contributor

Good evening,

I had a power outage, when the power came back on the Ruckus router came on but only has 1 yellow light and 1 green light. The two access points have no lights. I have cycled off the router and the internet provider and let them both sit for over 20 minutes. Plugged in the provider first and then waited 5 minutes and then the router and nothing happened. 



Hi @kdpjay33 

Thank you for contacting Lennar Home Community.

Hope you are doing well!!!

Thank you for the detailed information you shared,

As per the case description, I could understand that after a power outage, your ICX-7150-C12P Switch has a Yellow and a Greenlight and there is no power on Access Points.

If it is an amber/orange light on the "SYST" and a green light on the "PWR" on the Switch. Meaning the Switch is stuck in the boot mode.

Basically, due to the power outage/ power spike, the switch went to a state that we call ‘boot mode’ that is not able to boot up properly. 

First, we will try to reset the Switch as described below:

1. Please try to disconnect from the Power outlet the ICX-7150 and reconnect.

2. Please try to press the reset button using a paper click or a small stick 

  • Remove power from the switch.
  • Press and hold the Reset button while applying power to the switch.
  • After all the system LEDs flash amber, release the Reset button.

Below is the Guide and Videos link for your reference:

Video link:


IF RESET DOESN’T WORK: Please follow the below steps.

If the reset does not make any difference, we need to perform a software recovery since it can be that the image flash is corrupted in basic words the unit is not able to boot up properly and need re-install the image to boot up properly.

Below is the Guide and Video Link to perform the Software recovery process:

Please refer to the below guide and Video link:

Video Link:

Please let us know once you finish this process. So that we could assist you in upgrading your Switch to the latest stable version to avoid these issues in the future.

Please let me know if you have any queries in this regard.

Thank you again for your patience.


Best regards,

Imran Sanadi

Lennar Home Community.

View solution in original post