- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
12-31-2022 07:55 AM
Ruckus switch is not showing in the dashboard, does this mean the switch is not working ? Tried adding manually, but I am not sure of IP address. When I run the IP scanner, showing two AP IP's but not finding the Switch IP I guess. Any suggestion how to add switch to dash board first. Then I can continue debug the rest.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2023 07:15 AM
It all worked atlast. Thanks a lot!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-02-2023 02:42 PM
Hi @ra507102234
Take in consideration that the credentials you need to use, are the ones you created during the configuration, or the same you used when you gained access via telnet.
Best regards,
Yarenis Hernández.
Technical Support Engineer | L2 TAC Wired | Lennar Home Community
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-02-2023 02:45 PM
I didn't have to give anything to gain access. Don't remember if I had changed this before. Anyway to reset this to what I wanted now ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-02-2023 02:55 PM
Good news. Switch is connected now. How do I make sure things are in order ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-02-2023 02:59 PM
Hi @ra507102234
Great, 😎 you can test connectivity, however you should not have any issues.
Best regards,
Yarenis Hernández.
Technical Support Engineer | L2 TAC Wired | Lennar Home Community
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-03-2023 07:15 AM
It all worked atlast. Thanks a lot!