Ruckus is on, but both R510 Extenders does not show any lights on it.
1 ACCEPTED SOLUTION
I am getting this error after I entering the command: "Boot system flash memory"
Hi @bkpatel009
Thank you for the response.
The Upgrade path would be 08061a (your current version)>>8080f>>8095g
Please enter the below commands and start the Upgrade to 8095g (08.0.95g)
enable
copy tftp flash <ip of your tftp server> mnz10114
From the step in the guide of below screenshot:
Your Upgrade folder should contain below files:
Sharing the TFTP Upgrade link once again below:
The following guide is an example of an upgrade via TFTP server, by using an application (FREE) to send files or upload remote files to a device, in our case, we will use it to update a new version to the Switch, basically, it will send the image version remotely from the computer to the switch.
How to upgrade a Switch ICX7150-C12P via TFTP
Please upgrade as explained above/from the link and let me know if you are stuck at any point or have any queries in this regard.
Thank you again for your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
This is what I am getting so far
This is what I am getting so far
Hi @bkpatel009
Thank you for the response and the information.
Could you please check and confirm if you have created a separate image folder as highlighted in the screenshot below? (Folder name is ‘Upgrade’ in below screenshot example)
Also please make sure, TFTP is correctly configured with the correct folder and Server interfaces as marked in the below screenshot as an example.
Please check and confirm once. And share the screenshots of the same.
Thank you again.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
