Ruckus ICX 7150-C12P

[bkpatel009]

Ruckus is on, but both R510 Extenders does not show any lights on it.

[Jayavidhya]

Hi @bkpatel009 

Please try to download the TFTP application named TFTP 64 using the below link.

Link TFTP 64: https://bitbucket.org/phjounin/tftpd64/downloads/

Please let us know if you have any queries in this regard.

Best regards,

Jayavidhya

Lennar Home Community

[bkpatel009]

I used all the combinations of username and password that were mentioned in the forum, but I can't login.

[Jayavidhya]

Hi @bkpatel009 

Please try the most common username and passwords ( This is key sensitive so please include capital letters )  

Username:admin password: Ruckus! 

Username:admin password: Ruckus1

Username:admin password: Lennar

Username:super password: sp-admin

Admin usernames and passwords for the Ruckus Wi-Fi Access Points/Switch for Lennar home users

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/Admin-usernames-and-password...

Please let us know if you have any queries in this regard.

Best regards,

Jayavidhya

Lennar Home Community

[bkpatel009]

Hello Jayavidhya,

I tried all the shown combinations of username and password numerous times, none of them seem to be working in my case. Please help me out with the next steps to figure out the passwords. Is there a way you may be able to help me by getting access to my screens remotely. As it's been quite a bit we've been going back and forth, Please.

[Jayavidhya]

Hi @bkpatel009 

Thanks for your response.

If default credentials do not work, please follow the below steps to reset the Password on the ICX-7150-C12P Switch

Please follow the below guide to perform password recovery:

Password Recovery on a Ruckus ICX Tutorial video

https://www.youtube.com/watch?v=XJS28DWbHM4

Recovery Process:

1. Console access to the switch.

How to console in the ICX-7150-C12P

https://community.ruckuswireless.com/t5/RUCKUS-Support-for-Lennar-Homes/How-to-console-in-the-ICX-71...

     2. Reboot the switch with the console cable attached and press "b" until the following is displayed.

• Enter 'b' to stop at boot monitor:  0

1. Using the following commands to remove the password

• no password
• boot_secondary

Now again reset your new credentials as mentioned in the steps below:

Edit the current or create a new password and username by using the below commands:

enable

configure terminal

device(config)# username super password pass

Where the username is ’super’ and password ‘pass’

 
In order to allow the correct authentication please run the following commands:

 
Device(config)#crypto key generate rsa

device(config)# aaa authentication login default local

Now you could try using your new credentials to log in.

Please let us know if you have any queries on this regard.

Best regards,

Jayavidhya

Lennar Home Community