Ruckus 7150-C12P WiFi not working after storm

[mbotkin]

Lennar home, first owner. Been using the Ruckus with our home since 2019. After a power outage 2 weeks ago our ruckus network hasn't been performing. Our LAN and wired connections work fine but WiFi is showing connections but nothing loads or it's greatly reduced. We've rebooted the Ruckus many times and rebooted the WAPs but it's not working for WiFi. Not sure what to do or if this is a hardware problem. I’ve also flashed the APs and updated the firmware to 200.15 and the issue still persists. Hardline connections are working throughout the home, WiFi shows connection and either is very slow by normal conditions, doesn’t load others, or works normally for others. The majority of the time it shows connection for WiFi but nothing loads despite having full signal connection.

[mbotkin]

Because this thread is getting really dense, what am I needing to do on this next attempt?

Plug my Mac laptop into the Switcher and then what steps after?

[Imran_ruckus]

Hi @mbotkin 

Greetings!!!

Thank you for the response and the update.

As mentioned before, could you please try to get console access using a Windows laptop?

Please refer to the below RUCKUS Lennar Knowledge Base self-help article for the process.

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Establishing-Console-CLI-Acc...

Thank you again for your patience and understanding.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support

[mbotkin]

I do not have access to a windows laptop. 

[Imran_ruckus]

Hi @mbotkin 

Thank you for your response.

To assist with obtaining console access on a Mac, please refer to the following video:

Video on Console Access for Mac

Additional video: https://www.youtube.com/watch?v=ZUREx-161H4

Kindly disregard the drivers demonstrated in the video. Instead, please download and install the drivers listed below before accessing the switch via the Mac terminal:

Mac iOS System Solution:

Install the necessary drivers to enable communication with the switch (ICX-7150-C12P) using a USB Type-C to console cable.

Drivers:

• Silicon Labs USB-to-UART Bridge VCP Drivers
• Ruckus Brocade ICX-7150 USB Serial Driver for Mac

Please let me know how it goes.

Thank you for your patience and understanding.

Best regards,

Imran Sanadi
RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @mbotkin 

Greetings!!!

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it.

If we do not receive a response from you within 24 hours from the timestamp of this message, your case will proceed to closure.

Thank you.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support