No Power AP R510

[Ruckus2]

Hi there.  I have now received two replacement units.  Both units also had no power despite connecting to the POE and 12 volt plug.  The same 12 volt plug has no problem powering other devices, so I know the plug is working fine.

What else can be done besides continuing to receive new units?  Is there a possible technical issue here?

[Imran_ruckus]

Hi @Ruckus2 

Greetings!!!

Thank you for your recent correspondence and update.

We may need to check some configurations of your RUCKUS ICX-7150-C12P Switch to troubleshoot this issue.

To proceed with troubleshooting the issue, please follow the steps outlined below to access the Command Line Interface (CLI) and provide the necessary command outputs:

1. First, identify the current IP address assigned to the switch ICX-7150-C12P by your local router. You can use an IP scanner tool to easily locate the switch's IP address on your network. Here is a guide on how to perform this using IP Scanner free applications: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-find-the-IP-Address-o...

2. Once you have identified the IP address of the switch, proceed to access the Command Line Interface (CLI) of the RUCKUS ICX-7150-C12P switch. Here is a guide on how to access the CLI: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-access-the-Command-Li...

If you can access the Command line the prompt should look like below:

ICX7150-C12 Router> OR

ICX7150-C12 Switch>

3. After successfully accessing the CLI, please execute the following commands and provide the outputs:

   enable

   show version

   show flash

   show inline power

   show inline power detail

   show interface brief

Please share the command outputs or screenshots if you encounter any issues or errors during these steps. 

Feel free to reach out if you have any questions or require further assistance.

Thank you for your cooperation and patience.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @Ruckus2 

Greetings! 

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it. 

Your prompt response would be greatly appreciated.

Thank you for your attention to this matter.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @Ruckus2 

Greetings! 

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it. 

Your prompt response would be greatly appreciated.

Thank you for your attention to this matter.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @Ruckus2 

Greetings! 

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it. 

If we do not receive a response from you within 24 hours from the timestamp of this message, your case will proceed to closure.

Thank you.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community