Similar to other posters, a power outage always causes issues for my ICX-7150-12CP and the two associated APs. I went through the manual reset of the switch but the amber lights just blinked continuously. Currently, the power light is green and the system light is yellow. No lights are on for either AP. I've seen a lot of different and complicated instructions in different forums. Which instructions should I follow?
Note: after fixing the issue of the Switch been stuck in boot mode, please perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin, so perform the software recovery using the code 08090k with the upgrade image file named SPS08090k.bin, then when the switch is back to normal upgrade to the file SPS08095gufi.bin for both partitions primary and secondary.
1.Upgrade a Switch ICX-7150-C12P using a USB flash drive
Effective November’2022, ‘Ruckus Support for Lennar Homes customers will no longer be handled by phone or email. We will be exclusively supporting customers via this community forum support model.
I understand that the steps may be somewhat new, however, we cannot replace the chassis until you confirm that the hardware is damaged. We have tried to create the guides as non-technical as possible, so that they are not difficult to follow; however, if you continue to have difficulty following the steps, I would recommend that you seek outside help or a technician.