Lennar ICX box no longer turning on

[hangity]

Ruckus ICX 7150 no longer powering up. No lights at all on the switch.  Tried multiple different outlets, power cords, etc.   The access points in the ceiling are not powering on either. Not sure when it happened. I just noticed it when I realized the Kevo Plus that was attached to the ethernet was no longer working. I suspect just faulty equipment.  Is there another solution for this problem here?

[Imran_ruckus]

Hello @hangity  

Greetings!!!

Thank you for providing the information.

Based on the details you've shared, it appears that your RUCKUS ICX-7150-C12P Switch is not operational.

If that doesn't work even with a working power cord or other power outlets, I recommend again attempting a physical factory reset multiple times, as outlined in our RUCKUS Lennar Knowledge Base self-help article accessible through this link and VIDEO: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/Process-for-performing-a-phy...

Video link: https://www.youtube.com/watch?v=6jHMTdo_hK4

If the initial reset attempts do not resolve the issue, please try resetting your switch multiple times (approximately 10-15 times) using the method described in the article. In some cases, repeated attempts have successfully resolved similar issues. Upon successful reset, the SYST and PWR lights should turn GREEN.

Please proceed with these steps and let me know if the switch powers on successfully afterward.

Thank you for your patience and cooperation in this matter.

Best regards,

Imran Sanadi  
RUCKUS Lennar Home Community

[Imran_ruckus]

Hi @hangity 

Greetings!!!

I trust this message finds you well.

I kindly request an update on the status of the issue so that we may proceed further with resolving it.

Thank you.

Best regards,
Imran Sanadi
RUCKUS Lennar Home Community

[hangity]

Hello, apologize for the delay.  I’ve tried multiple times to reset the device according to the video and instructions, including with other outlets, but with no success. 

[hangity]

To clarify: tried resetting it with the reset button and paper clip a few times as well and still no power or light indicating the device is working